Model NO.: LC
Max.Capacity: >400 L/min
Material: Cast Iron
Assembly: Liquid Pumps
Start Up: Electric Pump
Application: Submersible Pump, Sewage Pump, Oil Transfer Pump, Chemical Pump
Theory: Centrifugal Pump
Certificate: ISO 90001
Transport Package: Wooden-Case
HS Code: 8413709990
Driving Type: Motor
Structure: Multistage or Single Satge
Type: Sea Water Pump
Performance: Wear Pump
Why choose us?
Specialized production Manufactory for Vertical Turbine Pump
Focus on technological innovation, Over Industry leading level
Good experience at Domestic and oversea market
Carefully paint for Good appearance
Years of International service standards, Engineer one-to-one service
VTP series Long Shaft Vertical Turbine water pump for pump station projects
√ Corrosion resistance main part material, SKF bearing, thordon bearings suitable for sea water.
√ Excellent design for high Efficiency save energy for you.
√ Flexible installation method suitable for different site.
√ Stable running, Easy to install and maintain.
Application and purpose
Petrochemical Industry pump
Seawater desalination plant or salt water pump
City flood control and drainage
Sewage treatment engineering
|Working Temperature||0-60 oC|
This kind of vertical drainage pump is mainly used for pumping no corrosion, temperature less than 60 °C, suspended solids (not including fiber, the grits) less than 150 mg/L content of the sewage or waste water. LPT type vertical drainage pump is in LP type vertical water pumps, and on the basis of the increase and the collar, set the tube oil lubrication is water. Can smoke temperature below 60 °C, send to contain a certain solid grain (such as scrap iron and fine sand, coal, etc.) of sewage or waste water.
√ Long Shaft Vertical Turbine Pump Structure Advantage
1.The inlet shall be vertical downward and the outlet horizontal above or under the base.
2.The impeller of pump is classified into enclosed type and half-opening type, and three adjustments: non-adjustable, semi adjustable and full adjustable. It is unnecessary to fill the water when the impellers are fully immersed in the pumped liquid.
3.On the basis o Pump, this type is additionally fit with muff armor tubing and the impellers are made of abrasive resistant material, widening the applicability of pump.
4.The connection of impeller shaft, transmission shaft, and motor shaft applies the shaft coupling nuts.
5.It applies water lubricating rubber bearing and packing seal.
6.The motor generally applies standard Y series tri-phase asynchronous motor, or YLB type tri-phase asynchronous motor as requested. When assembling Y type motor, the pump is designed with anti- reverse device, effectively avoiding reverse of pump.
More detail about our VTP series Long Shaft Vertical Turbine Pump for curve and dimension and data sheet please conatct Tongke.
Note before order
1.The temperature of medium shall not be higher than 60 .
2.The medium shall be neutral and PH value between 6.5~8.5. If the medium is not consistent to the requirements, specify in the order list.
3.For VTP type pump, the content of suspended substances in the medium shall be less than 150 mg/L; for VTP type pump, the max. Diameter of solid particles in the medium shall be less than 2 mm and the content less than 2 g/L.
4 VTP type pump shall be connected with clean water or soapy water outside to lubricate the rubber bearing. For two stage pump, lubricant pressure shall not be less than operational pressure.